ABC Warrior WIP

weaselflinger

Sr Member
Always wanted to take a crack at one of these and I finally got around to it. Still need to work out the greeblies on the sides of the head and the pistons for the jaw and neck. I made a couple minor design changes here and there, but overall it's coming along well.
ABC1.jpg
 
What you're seeing in the pic is scratchbuilt. Chavant on top of poster board. I haven't molded or cast it yet, but plan to slush cast them in urethane resin.
 
Great work! The ABC Warrior is one of my favourite robot designs from any movie. Really looking forward to seeing this one finished. :)
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top