custom lightsabers

parfaitelumiere

Sr Member
RPF PREMIUM MEMBER
Hi there,

Here are some lightsabers I have modifed or fully scratch made:

The first is a park saber,this is my first complete saber.

p1070023.jpg

p1070024.jpg


However I didn't like the big control box and how it's fixed,narrow aluminium tube and emitter.
The brass bolts were rough,and I didn't like the one on the pommel,I did't like the small bolt on control box to lock the board.
I decided to modify it.
First,I polished the brass bolts.
Second I modified the control box,to make it lower,I made a bevel and round corners.
I added the brass screw on the side,to create a "blade adjustment controller"
I polished the first black ring to let it aluminium color.
I added a carbon fiber tube on the aluminium tube,drilled it,and installed the control box.


before:


p1070012.jpg


after:

p1070011.jpg


It's not yet finished,the made change will be on the emitter "claws'
I will do a general polishing too.
 
Thanks a lot.
The parks will wait a moment to have the definite finish,because of the 1/16" bolts,here I have only tools for 1,5 or 2mm bolts.
in fact I would find something more conventionnal to replace the claws,but I don't know what to use.
I can shorten the hilt too.
I hope to find a aesthetic solution...
 
Very cool! I like them both. Although I would like to see some more detail on the second one, it doesn't look like it is finished.
 
Hi,
It's just a empty tubing for the moment....

I have taken a shot with two positions:

p1070017.jpg


I have to find a 1,25" od 1" ID tube,with a cheap shipping cost to France instead of the 85 bucks they ask for sending a 4$ item on ebay....
If someone in USA has this kind of tubing,would be really great!
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top