Tron Legacy Baton

ripleys clone

Well-Known Member
I was wondering if anyone has thought about making a replica of it.

Measurements or pics. I have these 2 photos of it.

Thought about trying to make one out of styrene or maybe even a wooden rod.

Any thoughts you guys!!


"LAR"

5265243079_196f374294_z.jpg


5265849798_a80cb867c6_z.jpg
 
I don't have the skill set to make one but I would love to watch one of you talented folk do it and make it available in the JY...:love
 
I was holding out for Sideshow, who were, at one point, working on a Baton+Disc replica set. But seeing as it's been a few years now, I'm guessing that's a dead project.
 
Wow I had totally forgotten I started a drawing of one of these way back, never got around to finishing and uploading it.
I came up with an overall length of 10.5 inches based on scaling all the pictures I could find at the time.

8047725727_139bdc8bfa_z.jpg
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top