TOS Enterprise Transporter room 1:12 scale

Hemble

Well-Known Member
Hi All,

I picked up a few of the Mezco Trek Figures and decided to make a few displays for them. The first one is the transporter room and I made it using foam board, balsa wood, plastic card and greeblies from the local hardware store.

Ron

tr1.JPG

tr2.JPG

tr3.JPG

tr4.JPG

tr6.JPG

tr7.JPG

tr8.JPG

tr9.JPG
 
Loving this! :)

Thanks Sofaking.

Ron

- - - Updated - - -

Yep, me too! :cool

Thanks again joberg.

Ron

- - - Updated - - -

brilliant - certainly different - never seen this before

Cheers Gimme Shelter and besides this and the bridge I want to do the sickbay as well.

Ron

- - - Updated - - -

Nice!
If you wanted to crank it up a notch, had you considered using small fresnel lenses (like the prototype) for the pads?

http://www.awi-industries.com/OPTICS_fresnel.html

Cheers Mograph and thanks heaps for the link that will come in very handy.

Ron

- - - Updated - - -

Love it!!!

Cheers CJ.

Ron
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top