Star Trek TOS Phaser Rifle

One last thing. It needed a stand.

IMG_6986.JPGIMG_6985.JPGIMG_6984.JPG
 
Hey folks, I've had some people ask about dimensions that I used to build this. Attached are some documents that should hep[ if you want to build one. These dimensions were based on photos of the actual prop. Some dimensions might vary slightly from the actual prop. But it's close. I've also attached some of the labels and files I used while building this.

RIFLEDIMS.jpegPhaserrifle.jpgbottomframe.jpg
 
oh thank you, so 38mm is the pipe or pipe of a vacuum cleaner or so, what i must find, to star the project :)

and this hole plexiglas / pipe modul is only glued ot screwed to the body?
 
oh thank you, so 38mm is the pipe or pipe of a vacuum cleaner or so, what i must find, to star the project :)

and this hole plexiglas / pipe modul is only glued ot screwed to the body?

Yes. The whole tube structure is held together with screws.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top