wolverine cowl - unused movie prop

BoosterGoldstar

Active Member
wolverine-costume.jpeg

Hello, I am curious if anyone has made this version of the cowl in a pep file. I am looking to make this for my friend. any help would be appreciated.
 
Anyone ever notice how the height of the box is about 4-5" and the mask may be just a front piece? If it were full headpiece I think it would be sitting upright, but its slanted back, meaning its a half or 3/4 mask, not a full head cowl
 
Anyone ever notice how the height of the box is about 4-5" and the mask may be just a front piece? If it were full headpiece I think it would be sitting upright, but its slanted back, meaning its a half or 3/4 mask, not a full head cowl
This picture of it makes it look like it's probably is only a 3/4 mask:
wolverine.png
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top