Luke ROTJ V2 lightsaber

Dan, can I also throw in a small suggestion: perhaps the facets on the pommel can be machined with fillets (rounded)? This is an extra CNC operation, but gives a better result. The sharp edges bother me a bit.
 
Last edited:
Is my V2, spinning emitter 2nd run with uneven rings, not the unibody.
But I believe the unibody has the same shape.

Unibody has same details, different orientation of some parts, and is completely static, meaning it is one whole single connected piece. Hence, Uni-body (1 Body). Yours isn't because it is 3 separate pieces.
 
Dan, will you be incorporating both holes on the emitter (not the ones on the nipple, but the ones under the flange that pretty much line up with those) in the next run?
 

Attachments

  • IMG_1486.JPG
    IMG_1486.JPG
    108.6 KB · Views: 1,300
  • IMG_1662.PNG
    IMG_1662.PNG
    1.4 MB · Views: 287
I still haven't even started on Dan's earlier 'spinner' V2 lol.

Now that there will be another run, I'll probably sell it off.

Will the late summer run be uni-body?
 
I've seen many things on this saber that turned out not there, so I can't trust my eyes.:p To those that have seen it up close: yay or nay?
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top