Vader's MPP shroud (update)

Wrinkle paint will give you different types of finishes depending on how it's used. Heat is recommended while curing and direct sun light helped my 2 finishes. The uneven look shown in my photo was due to partial sun light

To me, the shroud paint looks like a texture vrs straight finish. I don't believe it's a hammered finish but I could be wrong
 
Re: Vader's MPP shroud

Indeed I think their complete MPP is also the same as Parks ... would make sense ... perhaps Roy or any of you guys should contact Tim for 'endcaps only' to become also seperately available to convert a Heiland further?

Chaim
I had an email reply from the saber shop, they said their parts for the mpp and graflex come from parks.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top