robpauza
New Member
Hi everyone,
I've been a member here a while but haven't really posted anything, so I'm long overdue.
I just completed a fully scratch built Thor Hammer and thought I'd share. All 3d modeling/3d printing/finishing & painting was done by me. There's a ton of different versions of this floating around, so I really wasn't going for full accuracy, and definitely took a few liberties. I'd love to hear your thoughts.
Here is the finished 3d model: (done in Lightwave)
I added an Asgard emblem to the end of the handle:
Here's a quick 3d render: (rendered in Keyshot)
And a closeup render of the Asgard emblem on the handle: (I ended up enlarging it on the final version)
I broke it up so it would print in pieces. I used my Raise3D N2 printer with Hatchbox PLA. Took about 90 hours to print.
I also modeled and printed a base. I think the print time was about 40 hours on this.
I made a base plate in Illustrator and laser etched/cut it:
Here's after some filling/sanding and some painting:
I've been a member here a while but haven't really posted anything, so I'm long overdue.
I just completed a fully scratch built Thor Hammer and thought I'd share. All 3d modeling/3d printing/finishing & painting was done by me. There's a ton of different versions of this floating around, so I really wasn't going for full accuracy, and definitely took a few liberties. I'd love to hear your thoughts.
Here is the finished 3d model: (done in Lightwave)
I added an Asgard emblem to the end of the handle:
Here's a quick 3d render: (rendered in Keyshot)
And a closeup render of the Asgard emblem on the handle: (I ended up enlarging it on the final version)
I broke it up so it would print in pieces. I used my Raise3D N2 printer with Hatchbox PLA. Took about 90 hours to print.
I also modeled and printed a base. I think the print time was about 40 hours on this.
I made a base plate in Illustrator and laser etched/cut it:
Here's after some filling/sanding and some painting: