SS A-Wing Hull Patterns and build

Little update I cut out the missile tubes on each side.......and then
fitted the supports for the hull on each side. I also made a new buck
for the canopy rail and cone.......and reshaped the part the that sits
behind the canopy.

I used a hinge so I could have access to the wing nuts that will
hold the engines on the opposite side of the bulkhead. I glued
the lower piece of support in place for the hull.



PAttern for canopy rail and cone....Thats all this part will be used for I will
make the clear part pattern by sculpting it on the rail.


http://i8.photobucket.com/albums/a40/3dimensionalmanagement/Studio%20Scale%20A-
wing%20V2/IMG_20150321_135256_492.jpg



Re-shape on this part as it runs a little flatter on the top......
Pic Vs. formed one on the right before re-shaping

I also cut out a center insert for the top hull it's not
glued in place yet. Thats the old canopy bulkhead sitting
on there before the re-shape...
 
Had to re-shape the nose at the end of the rail.... I am pretty happy
with it now.




Left most of the mass not dremeled out so I could work on the cone without it flailing around.






 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top