3D Printing Iron Man MK46 Suit

Working on the ab section and here is part of the back these prints didnt turn out so well but at least they are fixable
8212a64dc0884fd8f8d93f47c37e32fc.jpg
de6ba695a61ec18c62cfa20fc62a971e.jpg


Sent from my SM-G935F using Tapatalk
 
Heres what the torso looks like so far and im sad to say it does not fit me due to weight gain :( hopefully i can shed a few to be able to fit into it but here what it looks like so far on a mannequin
f1f843dc14de6dd16795379aad66ca72.jpg
36bde737dd48086646229892508d5117.jpg
b0434a9ae267a2803370ff69ef9ba7c5.jpg


Sent from my SM-G935F using Tapatalk
 
Hey man this is awesome! I am making the same kit right now. Would love to see some updated progress where you left off.....

Cheers!
 
Hey man this is awesome! I am making the same kit right now. Would love to see some updated progress where you left off.....

Cheers!
Thanks havent done anything on this for a while as been working on other projects to boost my skills dont honestly know when i will go back to this but i highly doubt it will be this year.

Sent from my SM-G935F using Tapatalk
 
Yeah Im using meshmixer such a good program to use yeah I hate when the suit looks like a bobble head my problem with my MK6 was that it was meant for 6ft and im only 5ft 8in so I had the knees buckling in on each other which looked terrible and measuring for pepakura is a pain makehuman is so easy. Are you going to post your war machine build?


by chance do you still remember what you scaled to , I have a 6' mk46, and I am also 5'8"
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top