M1 Terminator Endo Skull

Spoons

Well-Known Member
Hi all,

I'm thinking of selling my original M1 Endo skull but I need to find replacement ball bearings and metal strips which hold the eyes in place.
I gave the skull to Elstree Props (years ago) to put together and chrome but it never happened and was returned to me minus these small parts.
Luckily they were minor parts but I need them none the less.

Does anyone have any of these or can at least give me the measurements.

The measurements may need to be taken from an M1 as I don't know if sizes vary from the other skulls out there.

Thanks
 
I could check mine and measure those. You could go for some original parts, they should be easy enough to get a hold of. I don't remember exactly what they were but I remember reading about it on the Endobuilders' forum :)
 
Great tip. Thanks.

Didn't think to look on there.

So balls are 4mm, and the unbent ball holder-thingymajig is 50mm long, 3mm wide in the middle and ALMOST 5mm at the ends.
a quick and dirty cellphone photo:

DSC_0611.JPG
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top