ScorpionTR
Active Member
What the title says.
Can it be done well? Can I see pictures if possible?
Can it be done well? Can I see pictures if possible?
Power Ranger EVA Foam Helmets-Yay or Nay?
- Thread starter ScorpionTR
- Start date
theflightyellz
Well-Known Member
Yeah, it's 'do-able', but you can't really make details that sharp or clean in foam.
There's a thread here with someones results https://www.therpf.com/showthread.php?t=157270
(And a fair few more attempts if you do a google image search for 'Power Rangers Helmet EVA Foam) in total honestly though, sculpt in clay then fibgreglass is where you want to be if you're looking at a well finished ranger helmet.
There's a thread here with someones results https://www.therpf.com/showthread.php?t=157270
(And a fair few more attempts if you do a google image search for 'Power Rangers Helmet EVA Foam) in total honestly though, sculpt in clay then fibgreglass is where you want to be if you're looking at a well finished ranger helmet.
ScorpionTR
Active Member
Most often I see that the mouth looks off. Couldn't I just have the mouth area any maybe some other parts 3D printed?
I just did a Lord Drakkon for Dragon Con. I am planning on creating a thread, but I used EVA foam and I think it turned out decent enough. I want to do a "real" helmet eventually.
Here's a post of the full costume:
https://www.reddit.com/r/powerrange...id_lord_drakkon_for_my_first_cosplay_attempt/
Here's a post of the full costume:
https://www.reddit.com/r/powerrange...id_lord_drakkon_for_my_first_cosplay_attempt/
ScorpionTR
Active Member
Not bad. The chest armour could be bigger and the helmet should be a glossy white and the visor should hide your face.
I think the chest armor is decent size, it's more put the beer down and go for a run that's causing the problem ha. I couldn't find a visor so I just used a see through vinyl pencil case. I plan on reworking some of this eventually but just needed something for dragoncon fast and cheap.
