Kenner Star Wars Rifle case

Being based on the figure case you would have a huge amount of room fro electronics, have you given any thought on what you would do in that area?
 
Being based on the figure case you would have a huge amount of room fro electronics, have you given any thought on what you would do in that area?
The Case will be cleaned up, but otherwise kept as is. I've wanted one for my vintage collection for the past 20 years or more. They are somewhat rare here in Denmark.
The premise behind my 3D design was what might an actual Star Wars blaster rifler had looked like, had the case been a toy copy of such a thing.
So I kept the major proportions, and parts. Like the three barrels, and the odd half can thing on one side. And tried to emulate the look of a blaster, as if it was in the movies... more or less.
 
Last edited:
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top