Anyone deal with "3D Creative Australia" before?

Panaflex

Panaflex

Sr Member
RPF PREMIUM MEMBER
Just wondering if anyone here has dealt with this vendor before. Looks like we'll done stuff but I don't know their track record.
 
Not directly but he has a reputation on here as a recaster. He's also earned a bad reputation on the Dented Helmet. Bentley O'toole is his name. I'm sure others here will say the same.




Sent from my iPhone using Tapatalk
 
whoami11 said:
Not directly but he has a reputation on here as a recaster. He's also earned a bad reputation on the Dented Helmet. Bentley O'toole is his name. I'm sure others here will say the same.

Sent from my iPhone using Tapatalk
Click to expand...

Thank you for the information. Good to know before it was too late
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Devious1978
Anyone make a ANH Stormtrooper helmet with movie lineage ?
Replies
3
Views
700
Devious1978
Devious1978
Raaven1990
How durable is a DIY Vader saber with 3D printed parts?
Replies
15
Views
622
SPY007
S
Anakins father
Lightsaber 3d modeling and blueprints
Replies
3
Views
537
Ridire Firean
R
Jamesfett
SPSABERS LEGACY. Anyone hear from him?
Replies
1
Views
217
JetSetWilly
JetSetWilly
blewis17
How Darth Vader's helmet from the original 1977 Star Wars was found in Australia
Replies
5
Views
1,443
vadermania
vadermania
Back
Top