TFA

redbutton

Sr Member
RPF PREMIUM MEMBER
Hi, I'm doing a TFA saber and can't get the rivet down in the notch of the t-track. So I tried a small piece of tubing - no good next I tried a small
nut between the rivet and the gun and made a niffy rivet shaped like a nut. Does anyone know how to do this? Would appreciate any help!
Cheers,
Steve
 
We tried brass tubing and it literally warped and smushed. forgot how soft brass is...

I do have a steel spacer/standoff, maybe that will do the trick
 
Hmm - does this still tubing have to be the size of the rivet head? Or smaller/

I should have said the bigger you get to matching the same size of the rivet the easier it works

Alittle larger doesn’t hurt either, just make sure the tube fits in the cut out of the grip :p
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top