REVANSSkywalker
Active Member
Do the grips in TLJ run the entire length of the graflex bottom or are they spaced like in the Maz box version from TFA?
TLJ graflex grip qurstion.
- Thread starter REVANSSkywalker
- Start date
No, they are the same as the other TFA hero saber (Finn's saber):
The numbers are slightly different than in this image: length grip: 88mm, cut notch: 7.0mm wide and 14.0mm distance from edges. The rivet head diameter is 5.6mm.
Roy
The numbers are slightly different than in this image: length grip: 88mm, cut notch: 7.0mm wide and 14.0mm distance from edges. The rivet head diameter is 5.6mm.
Roy
REVANSSkywalker
Active Member
Thanks Roy!!!
The better looking length IMONever was a huge fan of the Maz box grips
Me neither! They made a good choice imo. And I think they were more consequent throughout TLJ.
AnubisGuard
Master Member
Bumping this because I'm doing a TFA/TLJ conversion – the grips touch the bottom the the can, right? If so, how does the 3.5mm gap between the grips and the clamp work?
3-cell bottom: 92 mm (the 2 Roman's and 1 vintage bottoms I have actually stick out 92.5mm when pushed all the way in)
Grips: 88mm
Which leaves a 4mm gap. (4.5mm, in the case of my flash, which looks absolutely enormous.)
So...what gives?
3-cell bottom: 92 mm (the 2 Roman's and 1 vintage bottoms I have actually stick out 92.5mm when pushed all the way in)
Grips: 88mm
Which leaves a 4mm gap. (4.5mm, in the case of my flash, which looks absolutely enormous.)
So...what gives?
Last edited:
AnubisGuard
Master Member
That's more in line with what I'm seeing. I've modeled a 90mm version and am having it printed. Thanks!
PrinceZip
Master Member
AnubisGuard
Cool! Can you show me your grips when completed?
Cool! Can you show me your grips when completed?
AnubisGuard
Master Member
Sure thing.
Similar threads
