Disney Entrance Plaque

F

Fatherttam

New Member
Just finished my Disney entrance plaque. Everything (including the letters) was cut by hand from foamcore.
disney 1.jpgdisney 2.jpg
 
That is really really cool. The letters look amazing, especially knowing they were cut by hand.
I've been thinking about making one of these myself. I think I might have to get myself some foamcore now.
 
Kohrsfilms said:
That is really really cool. The letters look amazing, especially knowing they were cut by hand.
I've been thinking about making one of these myself. I think I might have to get myself some foamcore now.
Click to expand...

thanks. the foam was $1 so the whole project only cost like $6. once its painted and on the wall you can't really tell that its not something stronger
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Bootlegger137
Refinishing a Disney Grail?
Replies
0
Views
582
Bootlegger137
Bootlegger137
AvZ
Restoration job: need to identify a part (steampunk like) from John Carter (Disney)
Replies
10
Views
703
adamszki427
adamszki427
Mr. THX
Disney+ National Treasure: Edge of History
Replies
4
Views
1,098
teecrooz
teecrooz
Ryan Clinton
Maximilion from Disney's The Black Hole blade fingers
Replies
5
Views
823
Ryan Clinton
Ryan Clinton
Shriker1
Tron Identity Disc V3 (Public)
Replies
1
Views
1,314
Shriker1
Shriker1
Back
Top