Length of Vader ROTS lightsaber?

Pat Za Ponor

Well-Known Member
I was hoping someone with an MR Vader ROTS lightsaber could measure its length if it wasn't too much of a hassle. I'm going to be Vader from ROTS for Halloween and I'm working on his lightsaber.

Thanks!
 
Thanks for replying.

I'd like to know the length of the Vader Revenge of the Sith hilt only. (Not the graflex version on Mustafar, but the Vader one that wasn't seen in the movie)

Thanks
 
If you're not going for 501st acceptable accuracy, most of the prequel hilts were about 11 inches. That should be about right. Hope that helps.
 
The MR Ep III Vader is almost exactly 11 inches at the longest point of the shroud.

Sent from my SAMSUNG-SM-G930A using Tapatalk
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top