COMPLETE(?) Another Yoda Saber from a Bolsey flash build

Do you have any of the brass screws left? I'd be interested in a couple. I ordered a couple of the other screws from swaco.com PN: CLA-440-2 . These take a 4-40 screw and should work as an alternative for the top screw.
 
Re: Another Yoda Saber from a Bolsey flash build

So since I don't have the corvette oil pan model, and trying to keep the cost down on this one, I decided to make the activator with styrene...
http://farm8.staticflickr.com/7451/9440999992_1d6c85d724_c.jpg
IMG_0791

Do you know what is the exact Model Vette Kit was that was used?

i don't believe it's been found. Someone was selling casts of either the original or of proper sized one, but can't remember the member...


Someone will know. I'm on my phone so a pain to look up
 
Re: Another Yoda Saber from a Bolsey flash build

ok thanks... yours came out great btw


Thanks! It was a fun one. At the time I couldn't find any of the parts, so doing it all from scratch has made the saber one of my favorites. I actually like how almost every piece on it is slightly, or largely, inaccurate.
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top