Laser - AX - The Last Jedi First Order Stormtrooper Executioner Weapon 3D Print

Test run is ok! Except the pretty weak main rod. Ok, changed it to metal one!
 
Last edited by a moderator:
The path of prototyping))) Like one step ahead...two backwards..repeat)))
2017-09-29 12.06.43.jpg2017-09-29 00.25.08.jpg2017-09-29 00.24.46.jpg
 
Like the LE wire idea, I don't like the squeal the smaller battery packs make though (was gonna fit it to a Rep commando lid till I heard the squeal) that wont be an issue for the axe though.
Good luck with the print
 
Full build test-drive!))
All works fine!))
Now - paintworks!)))
 
Last edited by a moderator:
LEDs are installed and working!
Remote controlls are hidden in hollow accs!

 
Last edited by a moderator:
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top