Vader MPP bubble mounting

IMG_3095_zpsrofw6jlg.png
 
Nice. I happen to think the straight circuit lines are at the top and the angled circuit lines are at the bottom, but I could be wrong.
 
Can anyone with one of those cards with the LED modules on it do a quick measurement of the red plastic rectangle? Doesn't need to be super accurate, I am just trying to get a ballpark figure. In mm if possible.

Thanks
 
Can anyone with one of those cards with the LED modules on it do a quick measurement of the red plastic rectangle? Doesn't need to be super accurate, I am just trying to get a ballpark figure. In mm if possible.

Thanks
It is 4 mm x 6.5 mm
Sorry for I could only measure in metric

Gesendet von meinem SM-G930F mit Tapatalk
 
So ... is the general consensus now that this Exactra red led strip was used in Vader's V2 black sidebars MPP? :confused

Chaïm
 
If the Vader V2 has red leds, why aren't they showing up in the casino saber?


Sent from my iPhone using Tapatalk

Different strip... the basic Exactra strip along with the bubbles themselves were used for the ESB/ROTJ hero and not the red LED variant circuit board.
 
Thanks.
And to clarify a bit further- the red led board is being discussed in relation to the vader ANH black sidebars saber, not the vader ANH silver sidebars saber or any other movies.
 
Thanks.
And to clarify a bit further- the red led board is being discussed in relation to the vader ANH black sidebars saber, not the vader ANH silver sidebars saber or any other movies.

Aahhh!! This makes sense. So red dots only seen in ANH


Sent from my iPhone using Tapatalk
 
So as I mentioned earlier yet did not receive any reply ... whatever happened to that almost all round bubblestrip itself? Where did that go ... Luke's or OB1? Vader's V1 perhaps?

Chaïm

Your guess would be as good as anyone else's at this point I would imagine.... but it would make sense considering that all three of those ANH sabers used bubble strips...
 
Halliwax has a good point - this is generally suggested as the same black sidebar MPP flash unit.. ANH and ESB/ROTJ

I would guess that they re-worked the sabers and lost the rectangular red LED strip, or chose ONE hero and picked the bubbles.
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top