paulcliff
New Member
Hi all, first time poster here.
I am looking a doing a conversion on my 2 MR Maul sabers, the blades have gone a horrible yellow colour, looks like its on the inside so will need to be dismantled.
I am looking at buying one of the conversion kits from JQ Sabers (I'm in the UK) and using this guide: http://forums.thecustomsabershop.com/showthread.php?1024-06-MR-Darth-Maul-Done-amp-kits-available
I've not done any soldering since I was at school (17 year ago) but I'm eager to give it a go. I am slightly confused by the section in the guide that talks about cutting wires and re-joining them, it doesn't seem very clear to me, does anyone have a diagram I could follow instead or any advice?
As far as the blade goes, JQ Sabers have recommended I buy one of their blades then cut it down to 30" but I'll do that at a later date.
Anything thing else I need to know before proceeding?
I am looking a doing a conversion on my 2 MR Maul sabers, the blades have gone a horrible yellow colour, looks like its on the inside so will need to be dismantled.
I am looking at buying one of the conversion kits from JQ Sabers (I'm in the UK) and using this guide: http://forums.thecustomsabershop.com/showthread.php?1024-06-MR-Darth-Maul-Done-amp-kits-available
I've not done any soldering since I was at school (17 year ago) but I'm eager to give it a go. I am slightly confused by the section in the guide that talks about cutting wires and re-joining them, it doesn't seem very clear to me, does anyone have a diagram I could follow instead or any advice?
As far as the blade goes, JQ Sabers have recommended I buy one of their blades then cut it down to 30" but I'll do that at a later date.
Anything thing else I need to know before proceeding?