1/24 Joe Johnston Y-Wing

moffeaton

Master Member
RPF PREMIUM MEMBER
I'm getting better at Rhino!
Screen Shot 2018-08-29 at 11.07.09 AM.pngScreen Shot 2018-08-28 at 2.28.40 PM.pngScreen Shot 2018-08-28 at 1.22.56 PM.pngynot.jpg40351911_10156648811758156_9206144429109280768_n.jpg40353150_10156648811713156_8002482271061803008_n.jpg40236512_10156648811653156_5782761078484107264_n.jpg40321187_10156648811573156_1509277844553859072_n.jpg

More here:
https://www.facebook.com/roboterkam...dy0Qqd5h2TvQWOWegdD8hW6hnhV0TQfh5HdSBtZAaqGFQ

Screen Shot 2018-08-28 at 1.22.56 PM.png


Screen Shot 2018-08-28 at 2.28.40 PM.png


Screen Shot 2018-08-29 at 11.07.09 AM.png


ynot.jpg


40351911_10156648811758156_9206144429109280768_n.jpg


40353150_10156648811713156_8002482271061803008_n.jpg


40236512_10156648811653156_5782761078484107264_n.jpg


40321187_10156648811573156_1509277844553859072_n.jpg
 
I had the good fortune of getting to see Jason's build in person last week. Stunning work!
 
Impressive prints Jason!! The Form 2 is great!

And impressive design!!!

I'm advancing too on your McQuarrie design of the Bandai 1/144 Lando Falcon.

Keep up the good work!
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top