ANH stormtrooper from do3d.com

Thanks guys, it does indeed seem like do3d is not a good place to buy from. At least I'm not willing to risk it. I think I will try to model my own armor. Will probably be a long project :p
 
I would stay away! Aside from the vendor, the printer lines would need to be filled, sanded and painted. Seems like a lot of time and money just to fabricate TK armor. Also keep in mind its the fit of the armor not the kit. If you are serious about white armor you can learn more at FISD. www.whitearmor.net. You can even post your question there as well. Good luck!!
- 501st Stormtrooper
 
Last edited:
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top