Thanks! It's actually just the base coat.. Still needs all the weathering and detailing, just been super busy.
Here are a few good shots, and one of the grapple gun because why not.
View attachment 673182View attachment 673183View attachment 673184View attachment 673185View attachment 673186
Got my Bat Brander today and I kinda like it how it is lol.
Also got the spears. To my surprise they dont fit that well. Any ideas?
View attachment 673959
I wonder if I should try dremilling a bit. They are a bit small but they do there job wellI began opening up the holes using a drill bit. I opened them up somewhat but I'm gonna need a bigger drill bit.
Well, even in the tech manual, the 3D model on the left doesn't match the prop on the right... I've seen real physical props looking like the 3D model also, which is definitely different from the prop in the tech manual. Most notably are the little prongs at the end of the four small tubes around the main barrel, as well as the grips, which are in one solid piece wrapping around right under the trigger on one prop, but two separate pieces on the other prop. There are other subtile ones as well, I can only assume one was a prototype and/or a hero one while the other was a stunt model.
Speaking of which, here is my Rubies based on the tech manual reference :
View attachment 673831
Amazing thread guys! hope i can get that gun down the road to make my mod!
Any other alterations of other products? Like the different cowls available, the suits, etc?
Hunting, but not finding-where on God's green earth did you get the branding ring?!? Also, your wood painting is stellar!View attachment 672823View attachment 672822
All I've got on my phone at the moment. :lol I really need to sit down and finish this stuff. I've got the armored helmet sitting around waiting to be finished as well.
Hunting, but not finding-where on God's green earth did you get the branding ring?!? Also, your wood painting is stellar!