Hiya,
I am in the process of creating a replica of Deadpool’s Desert Eagles from DP2
I am creating a master, which I’m then going to mold and cold cast.
As I’m new to all this I’ve watched numerous tutorials on YouTube and most seem to do a 2 part mold.
It would seem logical to do this with the seam running down the centre of the gun
However, there will be lettering on the very end of the barrel (as you look at it) and a seam there will interfere with that.
Can anyone advise on a good way to mold this.
Thanks in advance
Noob at all this
I am in the process of creating a replica of Deadpool’s Desert Eagles from DP2
I am creating a master, which I’m then going to mold and cold cast.
As I’m new to all this I’ve watched numerous tutorials on YouTube and most seem to do a 2 part mold.
It would seem logical to do this with the seam running down the centre of the gun
However, there will be lettering on the very end of the barrel (as you look at it) and a seam there will interfere with that.
Can anyone advise on a good way to mold this.
Thanks in advance
Noob at all this