HELP: Making groot stick for stormbreaker

305primus

Active Member
Gearing up for a IW Thor build and as the titel says i need help with the handle of stormbreaker, the part I got stuck on is making the handle taper and go from wide at the pommel to narrow at the axe head, i only have access to basic materials like foam and pvc pipe so unfortunately 3D printing and sculpting/casting is out of the question for this one
 
Last edited:
Glue multiple sheets of foam together to the thickness you want it and have a sturdy piece in the center before gluing the two halves together then draw your pattern on the top and bottom of the foam then carve the shape with a dremel

Sent from my SM-G935F using Tapatalk
 
Glue multiple sheets of foam together to the thickness you want it then draw your pattern on the top and bottom of the foam then carve the shape with a dremel

Sent from my SM-G935F using Tapatalk

Would it be sturdy enough with just the foam of should I have some sort of skeleton?
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top