Cheap PKD (Water Gun)

Patton's Blaster!!

Got some paint on mine. Starting to move away from looking like a squirt gun!
 

Attachments

  • 1015171226.jpg
    1015171226.jpg
    1.6 MB · Views: 229
Ok after seeing all of these amazing upgrades I think I'm going to try it. Where are you guys getting the blasters at I regret not jumping on the Japan Hobby pre-order now. Still plenty on ebay fetching $60+ is the the going rate?
 
For weight what are you all doing? Epoxy and bbs, resin and fishing weights, ect.

I hate to burn up a ton of epoxy...im thinking hot glue and bbs but im worried the hot glue will dry too fast...what has worked for you all?
 
For weight what are you all doing? Epoxy and bbs, resin and fishing weights, ect.

I hate to burn up a ton of epoxy...im thinking hot glue and bbs but im worried the hot glue will dry too fast...what has worked for you all?
Was using air-dry clay and threaded rod but that shrunk. So about to switch to Epoxy Sculpt and threaded rod. Should add some weight but probably nowhere near the 1.5kg it should be.

Sent from my brain using the Tapatalk monkeys
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top