Zork ------- ONE ZORKMID

[Jintosh]

I saw the Zorkmid project and made up a quick coin to put on Shapeways.
It is 32 mm in diameter and 2.6 mm tall as per the specs on the Zorkmid project page.

In the spirit of the Project, there is no markup on the coin.

I ordered a coin myself and will post pics when it arrives.

 

[Jintosh]

hmmm....the requirements for bronze steel are higher than expected. Shapeways won't print it in bronze steel.
There goes the cheap option.

 

[Jintosh]

I resubmitted my design in bronze. It's more expensive, but has lower requirements. It should go through.

Will post pics when I get it.

 

[Jintosh]

Here's the render with the mottled background pattern.

 

[Jintosh]

The bronze from Shapeways looked very much like brass. These pictures are after adding a bronze darkening solution.