X-Wing question!!!

Discussion in 'General Modeling' started by DARTH SABER, May 15, 2018.

  1. DARTH SABER

    DARTH SABER Master Member

    Trophy Points:
    2,790
    So, there are two rods that run along the side X-wing canons and seem to go into the heat sinks. Do they curve down into the heat sinks or do they go straight into the heat sink ring?

    [​IMG]



    Sent from my iPhone using Tapatalk
     
    derrickzanni333 likes this.
  2. Treadwell

    Treadwell Master Member RPF PREMIUM MEMBER

    Trophy Points:
    4,325
    all the way to the ring.
     
  3. DARTH SABER

    DARTH SABER Master Member

    Trophy Points:
    2,790
    Hole drilled into the ring and inserted





    Sent from my iPhone using Tapatalk
     
  4. bigpetr

    bigpetr Member

    Trophy Points:
    138
    On RED 3 they are not inserted to the ring, they are just touching it. I do not mean it as nitpicking. Just technical note from SS standpoint for the record.:)
     
  5. DARTH SABER

    DARTH SABER Master Member

    Trophy Points:
    2,790
    Thanks!




    Sent from my iPhone using Tapatalk
     

Share This Page