1. Welcome to the Project Runs Forum!

    This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.

    Only Premium Members can start a new run.

    Click here for details on becoming a Premium Member.

    Click here for the complete Classifieds Guidelines.

    Dismiss Notice

Limited Run Working on a Batman (1989)/Returns suit? Get your accurate belt strap material here!

Discussion in 'Project Runs' started by gregday, Apr 4, 2015.

  1. gregday

    gregday Well-Known Member RPF PREMIUM MEMBER

    Trophy Points:
    915
    I have a roll of the correct original material that the 89 belts were made from (1988 Chevy truck side trim molding) that is doing me no good sitting around. This is brand new material, newly manufactured and not dry and brittle as if it were made in 1988.

    If you are working on an 89/Returns suit, this is the stuff you want. Way better than any molded strap and pretty tough.

    It will come to you as it did to me, in its original factory chrome finish with adhesive on the back (you will need to scrape off).

    You will be responsible for paint, buckle, and pods. I'm just selling the strap.

    I'm asking for $40 a piece shipped inside the U.S.,, cut to the length of your choosing (as long as that length is a reasonable waist size). I have about 30 feet of the stuff and I'll chop it up and sell it until it's all gone.

    Paint it yellow or gold and it will look fantastic with your suit. Below it is shown with Henry Wayne buckles.


    [​IMG]


    [​IMG]


    [​IMG]
     
  2. gregday

    gregday Well-Known Member RPF PREMIUM MEMBER

    Trophy Points:
    915
    Re: Working on a Batman (1989)/Returns suit? Get your accurate belt strap material he

    Okay everyone, the supply has run out. Thanks for your interest!
     

Share This Page