wolverine cowl - unused movie prop

Discussion in 'Marvel Costumes and Props' started by BoosterGoldstar, Sep 13, 2015.

  1. BoosterGoldstar

    BoosterGoldstar Active Member

    Trophy Points:
    342
    wolverine-costume.jpeg

    Hello, I am curious if anyone has made this version of the cowl in a pep file. I am looking to make this for my friend. any help would be appreciated.
     
  2. BoosterGoldstar

    BoosterGoldstar Active Member

    Trophy Points:
    342
    Anyone have any sugestions?
     
  3. BoosterGoldstar

    BoosterGoldstar Active Member

    Trophy Points:
    342
    Maybe I will just use jfoam's wolverine mask as a base and freestyle it to make look closer to this.
     
    WebSlingingHope likes this.
  4. Snakenator9

    Snakenator9 Jr Member

    Trophy Points:
    92
    That's honestly probably your best bet. Since it is such an unknown prop the chances of finding a file are not super great
     
  5. JLeezy23

    JLeezy23 Sr Member

    Trophy Points:
    1,981
    One member was working on a 3D print of this. Until he was found to be a recaster and sockpuppet and was banned
     
  6. Daftpunk

    Daftpunk Jr Member

    Trophy Points:
    92
    Unused you say? It's a perfect, hate that they didn't use that, I woulda loved it
     
  7. Magnum1911

    Magnum1911 Active Member RPF PREMIUM MEMBER

    Trophy Points:
    441
    Just out of curiosity, which film was this designed to be used in?
     
  8. TheNickFox

    TheNickFox Sr Member RPF PREMIUM MEMBER

    Trophy Points:
    2,285
    It was to be given to Logan as a gift at the end of The Wolverine.

    -Nick
     
  9. BoosterGoldstar

    BoosterGoldstar Active Member

    Trophy Points:
    342
  10. Magnum1911

    Magnum1911 Active Member RPF PREMIUM MEMBER

    Trophy Points:
    441
    Awesome thanks!
     
  11. JLeezy23

    JLeezy23 Sr Member

    Trophy Points:
    1,981
    Anyone ever notice how the height of the box is about 4-5" and the mask may be just a front piece? If it were full headpiece I think it would be sitting upright, but its slanted back, meaning its a half or 3/4 mask, not a full head cowl
     
  12. Pinkratgirl

    Pinkratgirl New Member

    Trophy Points:
    3
    This picture of it makes it look like it's probably is only a 3/4 mask:
    wolverine.png
     
  13. Talisen

    Talisen Sr Member

    Trophy Points:
    1,682
    It probably is, the entire set is 3D printed (to look like fabric etc) so there was no need to model the entire cowl.
     
  14. SWFreak

    SWFreak Well-Known Member

    Trophy Points:
    931
    I had read somewhere that it actually was just a 3D printed static prop. None of it was wearable.
     

Share This Page