Whittled Green Lantern Ring

colintendo

New Member
As a very first attempt at carving anything I've made this Green Lantern ring from a 2x2x2 inch block. Except for the hole on the face, I had to use a drill, it is completely hand carved. Just put this coat of acrylic paint on as the final touch, with a darker green faded in on the sides to make the face pop.

Estimating about 12-15 casual hours start to finish.

Sorry about the blurry pics, cell phone camera :unsure
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top