Wheatley Body problems!

Rushmoore

New Member
Hey :D
I am making wheatley from portal 2 and have made the outer body from a polyurethane sphere. I am going to carve out the sphere so it is hollow inside. I am going to cover the inside with wonderplast. I need a material to cover the outside. There is a lot of detailed work on the outside and I need a material that will strenghten the foam but not interfere with the detailed work. Is there a kind of resin I could use? Maybe bondo would work? I'm open to any suggestions, please help!


Thanks :)
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top