what do you think?

F

Fatesalign

Member
Hello everyone. I thought I would get a feel for interest in a project I'm going to start on today. I found this 3d print filament that has stainless steel powder in it and when polished, it looks like stainless steel.

Basically, I was going to be making an iron man arc reactor.
 
I would have some skepticism. It could look silvery....but not like stainless steel. Please post photos so we can see what it's really like.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

Kryptaos
How do I fix my Mjolnir?
Replies
0
Views
334
Kryptaos
Kryptaos
FastballSpecial
What company should take over the MCU prop replica licence?
Replies
9
Views
460
Synz314
Synz314
Firelord91021
What should I use as a Dr Doom armor undersuit?
Replies
0
Views
571
Firelord91021
Firelord91021
CGClone
Do you know what Wolverine jacket this is?
Replies
1
Views
860
CGClone
CGClone
JackRyder92
Do not buy from Val Kuperman on here/FB
Replies
5
Views
582
laellee
laellee
Back
Top