Welding Project Prop Ideas

Thread starter apocalypsehere
Start date Jan 19, 2012

apocalypsehere

New Member

Jan 19, 2012

I am currently learning to weld and for the final project I would like to recreate a prop of some kind, however, most of what i am looking at would probably be a bit cumbersome to make in steel as i see a lot of replicas being made from MDF and other light weight materials. I was hoping someone could help with any recommendations, as to what would replicate and work well out of steel with out major fabrication experience. Thanks.

This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.