voice changer kit

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Travis McGee

Active Member
So I just picked up this voice changer kit. What I would like to do is attatch a headphone plug so I can plug in an aux audio cable into it and the other side into a powered speaker. I've attached a picture of the compleated kit. I want to solder the plug to the two posts that are circled.

Thank you for any advice

Travis McGee
 

Attachments

  • voice changer.png
    voice changer.png
    791.4 KB · Views: 27

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

xl97

Master Member
Whats the question?

My first suggestion would be to ensure my 'headphone jack' (that you are referring to).. only has 2 pins/posts to work with.. as that seems what you have on the PCB to work with as well..
 

xl97

Master Member
Do you just use 2 prongs/legs? or do you short two of them together?

I thought 3 leg stereo jacks needed to be used with '3' ring/tiered plugs? (how will that work on his 2 prongs/leads on the PCB?)
 

Travis McGee

Active Member
Do you just use 2 prongs/legs? or do you short two of them together?

I thought 3 leg stereo jacks needed to be used with '3' ring/tiered plugs? (how will that work on his 2 prongs/leads on the PCB?)


The three prongs are left, right, and ground. Worst-case scenario it doesn't work.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

dbuck

Master Member
RPF PREMIUM MEMBER
I used just the two. Here’s a screen cap from a video I shot for someone I made a sound box for. Simple plastic box ( easy access for battery change) button trigger sound card, output jack for speaker amp.


C64F7D1A-08AC-42F0-9A49-3CC7413C0E5A.jpeg
 

kruleworld

Well-Known Member
Do you just use 2 prongs/legs? or do you short two of them together?
I thought 3 leg stereo jacks needed to be used with '3' ring/tiered plugs? (how will that work on his 2 prongs/leads on the PCB?)
I believe you use the sleeve and the tip, and not use the left channel.
This is why you use mono sockets/plugs if available. they can also be used for power connectors as well.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top