Viper Nameplate TTF Available


Active Member
Hey Folks..
There was a thread here a while back looking for the font that was used on the Battlestar Galactica Viper nameplates/hulls. I found a free font over at Font Struct called "Husker"

I've done a comparison to the nameplates in the Propwprks Auction and it's about 90% correct. See attached for one comparison. You'll need to tweek the characters just a bit to get it perfect. As the author says, that's part of the limitation of the tool.

But for comping or to get a concept started, it will work great and it's a fantastic addition to my font library. You can get it here.

FontStruct | Husker
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.