-
Welcome to the Project Runs Forum!
This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
Limited Run V4 Incom t-65 Limited run
- Thread starter mslz22
- Start date
Heisenberg07
Active Member
PM Sent.. 
JetSetWilly
Well-Known Member
Pm sent.
Thanks to everyone for their PM's, Interest in the kit is appreciated.
To address a couple of ?'s i have had.
I am expecting to get 4-6 kits done per week starting next week, I am using the rest of this week and the weekend to tie up some loose ends on orders like the galactica etc.
I am not limiting this to 1 kit per person. Any multiple kit orders will be combo shipped when they are done.
I am shipping in the order i received your PM.
I may not PM people back until their kit is ready, so if you don't hear back from me it's not that i missed you. I will likely compile a list here when i have a bit of time to do so.
I already have multiple molds for some stuff and will replace molds as i need to so everyone gets as fresh of a kit as possible.
The run will be limited to the point where I don't think there is enough interest to continue to make molds of stuff. For example if I find that I have filled most orders and it's down to a trickle, I would run out the existing good molds and that's it.
thanks again everyone.
mike
To address a couple of ?'s i have had.
I am expecting to get 4-6 kits done per week starting next week, I am using the rest of this week and the weekend to tie up some loose ends on orders like the galactica etc.
I am not limiting this to 1 kit per person. Any multiple kit orders will be combo shipped when they are done.
I am shipping in the order i received your PM.
I may not PM people back until their kit is ready, so if you don't hear back from me it's not that i missed you. I will likely compile a list here when i have a bit of time to do so.
I already have multiple molds for some stuff and will replace molds as i need to so everyone gets as fresh of a kit as possible.
The run will be limited to the point where I don't think there is enough interest to continue to make molds of stuff. For example if I find that I have filled most orders and it's down to a trickle, I would run out the existing good molds and that's it.
thanks again everyone.
mike
PM sent, Mike.
Karl
Karl
ThrakenSal
Well-Known Member
PM sent.
Similar threads
