Uruk-Hai Berserker helmet

BlindSquirrel

Sr Member
I made a Pepakura model of this Uruk helmet but finally got around to finishing it.

08.jpg


I used Smooth-On Roto to build up the helmet walls by slush casting on the inside. I then applied Bondo to the outside to smooth out the geometry. Fortunately, I didn't have to sand too much to bring it into spec with Orcish craftsmanship!

13.jpg


I Pepped the back plate but in the end it was just easier to heat form some 1/8" styrene.

16.jpg


The final pics!

30.jpg


31.jpg


32.jpg


35.jpg


Lots more detail and WIP pics on my blog!
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top