Update.. Countdown Timer, Added Comp Gauntlet, And Cannon Arm Wip

Just a small update

Got the bottom all done .

image.jpg


image.jpg
 
Last edited by a moderator:
where can I get a copy of the Cannon arm with all the little pieces. I want to make mine move also. Will get all of the servo's and gears, just need the arm and ect...
 
Hello everyone .. Sorry for taking so long on updates..

So here is where I'm at.

My Gauntlet is still not printed as I'm not happy with the results yet .. Also I will be making a small change to the lid. Pics will follow once I make the changes .

Now for my cannon arm. I've had great results with my prints . Now that I have all three parts printed. I cleaned them up and and ready to test fit..

For those that wish to buy my cannon arm .. There will be a sales thread started once I get it all figured out.
Until then it's not for sale.


Thanks for all the support ..



Lots of pics ahead :)

image.jpg

Cannon arm Base

image.jpg


image.jpg


image.jpg


image.jpg

Arm
image.jpg


image.jpg


image.jpg


image.jpg


image.jpg


image.jpg

Cannon Tilt
image.jpg


image.jpg


image.jpg


image.jpg
 
Last edited by a moderator:
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top