Tumbler build

Sean041776

New Member
Hi guys, I'm doing research for my Tumbler project, I'm going to build a 1:1 working replica. Can you tell if/where I could find the original schematics used by the design team for the original batman movie? if not could you give me some advice about how you guys would go about guessing measurements for things like the chassis?
 

Jawafive

Sr Member
Yep, Bob did his a few years ago, but I don't think that he had any plans from the film. Could be wrong on that, though.
 

PropReplicator2

Master Member
RPF PREMIUM MEMBER
Hi guys, I'm doing research for my Tumbler project, I'm going to build a 1:1 working replica. Can you tell if/where I could find the original schematics used by the design team for the original batman movie? if not could you give me some advice about how you guys would go about guessing measurements for things like the chassis?


Maybe over a vehicle with pvc frame?? The armor contents are up to you though. maybe a fiberglass armor for looks but for better effect you could take a longer time an go do aluminum or steel plating. Ive seen plenty of variations though so yeh.:)
Maybe check out this link for a simple one. http://www.instructables.com/id/Make-a-life-sized-Batmobile-Tumbler-and-Batman-The/
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top