Trooper Brow Trim Supplier

Jimbo890

Well-Known Member
Help.

I want to get some of the brow trim material, as used on the stormtrooper helmets, but I can't find the link. I guess it dropped off. I also don't want to pay what those guys on ebay are asking. I remember the source was in England, and it was a boat trim supplier. I can't remember the item number.

I should have book marked them. Oh, well. Can anyone help?

Thanks

Jim
 
The trim on mine isn't glued - it's just pushed into place and it works fine.

However, on the first trooper helmet I made, I used a few drops of superglue on the brow and that seemed to work too.

Regards

Al
 
Hey Chris,
x-wing helmet trim is different stuff than the troopers.
Tie pilots use the brow trim as their neck trim.
 
<div class='quotetop'>(ob1al @ Oct 3 2006, 04:57 PM) [snapback]1331324[/snapback]</div>
The trim on mine isn't glued - it's just pushed into place and it works fine.
[/b]


That won't work on an FX bucket, as the faceplate laps over the helmet dome. I would have to install the U shaped trim upside down, which is wrong.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top