Tron Legacy Identity Disc Revival

Shriker1

New Member
Hi, I'm New Here :3 Recently found the 3D Model of the Identity Disc made by I believe Devlin? Im just wondering if i can use Soul Inertia's Blade and C rings with it or if there are other alternatives for them. I'm tired of using the Original deluxe toys and want something i can rely on. here is the disc file. trying to get the outside diameter of the disc to 21cm.
Thanks for the help!
 
I just used the Identity disc model on thingiverse which is cut into 4 pieces and also comes as a full disc if that's any use

It requires a bit of finishing but looks better than the cheap toys
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top