Transformers props and models.

Ozymandius

Sr Member
RPF PREMIUM MEMBER
I've done a few of these for the Transformers forums but wanted to see if there was any interest here for these.


Cybertron model: 12" in diameter lit and unlit
FX 1 sm.jpgFX 2 sm.jpgFX 3 sm.jpgFX 5 sm.jpg

IMG_20190807_175840091.jpgIMG_20190807_175903070.jpg
Cybertron paint 1.jpgCybertron paint 2.jpgCybertron paint 4.jpgCybertron paint 5.jpg

Unicron's severed head. 21" tall with base. 16" wide.

Unicron 6 web.jpgUnicron 7 web.jpgUnicron full 9 web.jpgMetallic comparison 2.jpg
 

Attachments

  • Unicron full 8 web.jpg
    Unicron full 8 web.jpg
    294.9 KB · Views: 126
  • Prime grey 2.jpg
    Prime grey 2.jpg
    344 KB · Views: 159
  • Prime stand.jpg
    Prime stand.jpg
    300.7 KB · Views: 136
They vary between $650 to $1200 depending on how far you want to go. The lit one pictured is the full FX version with individual buildings lit from within and thousands of tiny windows carved out.
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top