Tie Fighter in the stand

DJSLY

Well-Known Member
RPF PREMIUM MEMBER
Hi all,

Small project on the base from the Tie Fighter 1/72 Bandai, it will be presented on its docking cradle.

It is maintained through a mini magnets which supplies also the LightUp.

I still have to finalize the base.


20150510.jpg


20150511.jpg


20150512.jpg


20150513.jpg


20150514.jpg


20150515.jpg


20150516.jpg


20150517.jpg
 

Tumbler

Active Member
Love the illumination pattern in the base. Fantastic! How did you create the holes in the mirror? Just remove the coating from the backside using a round dremel bit or something?
 

DJSLY

Well-Known Member
RPF PREMIUM MEMBER
Thanks Tumbler, CJ 617 for comments ;)

How did you create the holes in the mirror? Just remove the coating from the backside using a round dremel bit or something?

The base is formed with a mirror styrene sheet for passage of the optical fiber, I drilled with the Dremel.
 

jkno

Master Member
A superb diorama! I was waiting for someone to make a truly cool docking system for a TIE. AWESOME :thumbsup
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top