Thunderbird 1 launch bay

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


KevinD

Sr Member
Just finished this AIP kit of the Thunderbird 1 launch bay. It's a nice little kit but I needed to scratchbuild a fair bit. I changed the observation room which was really only moulded in relief. I cut it out and made a proper, glazed room. I made the slope inside the entrance way, replaced the cardboard floor with a plasticard one and added lighting and a roof!.
TB1launch3.jpg
TB1launch2.jpg
TB1launch1.jpg
TB1launch8.jpg
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top