Done / Completed Threaded Rod for Anakin Starkiller's 2019 Maul Run

corliss1

Sr Member
RPF PREMIUM MEMBER
Hey Crew!

This is to get people's attention for the threaded rod for Anakin Starkiller's latest Darth Maul saber run. Currently I know the following:

-One piece of zinc-plated rod from my supplier will be $4 plus shipping. It's a 3/8"-16 x 20.25" threaded rod. It will be pre-cut and the ends nicely finished so it will easily thread into the ends of the saber.
-I'm going to look into United States lower 48 shipping costs soon.
-If anyone in the EU would like to step up so I could do one mass shipment over there that would be amazing as everyone would get MUCH cheaper rates doing that than paying me to ship each individual package over. If that doesn't work out, international is fine, but will likely cost a bit as the box/package will at least be 21" long.

PRICING (including shipping)

USA lower 48: $19
International: $30

Sign up list:
JoeG - PAID
StClair185
Chr2win - PAID - (mattr)
mtrixman - PAID
Mark P
DarkJedi360 - PAID + shipping note
masterjedi322 - PAID
cboath - PAID
Darthlarry - PAID
Martin Sabers - PAID
Spankuh - PAID
ronwlim - PAID
kurtyboy x2 - PAID + shipping note
 
Last edited:
I'll do the first list update once I get the shipping quotes, so might be a few days until there's a list on the first post.
 
Not sure if this help anyone but I found 3/8 16x24 rods at Home Depot for $2, cut it down with my dremel and didn’t need to rethread it.
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top