zjunlimited
Sr Member
Next up is the aluminum part. I had to open up the insides to allow the red lens to move freely up and down but not too much that the lens will fall out or sit crooked. This took a lot of trial and error....sand, test fit, sand more, test fit...you know how that goes.
Edit: I also had to shave down (shorten) the base section so that there was enough spacing relative to the mid-section of the red lens for the lens to move up and down.
Edit: I also had to shave down (shorten) the base section so that there was enough spacing relative to the mid-section of the red lens for the lens to move up and down.
Last edited: